KEYENCE Visual KV Series - Manual (Page 46)

1.3 Device Configuration
3-22
1
Chapter 1 Programming
1.3.12 Relay Nos. and Functions
Assignment of Relay Nos.
The components of a relay no. are shown below.
■ Unit Nos.
Unit nos. are assigned to units within the KV-300 system, with the unit connected to
the right of the KV-300 CPU (see the figure below) assigned as no. 7. The CPU is
assigned as unit no. 0.
■ Address Nos.
Address nos. are assigned to the input units, output units, and I/O terminal units.
The following table shows the assignment of address nos. to units.
* The KV-R1A I/O Distribution Unit accommodates 5 input units and 5 output units.
Addresses are set with address switches.
0 7 5 1 5
Address No.
Channel No. Relay No. (00 to 15)
Module No. (07 to 17)
Input (0 to 4)
Output (5 to 9)
Power supply unit CPU
0 7 8 9 16 17
Unit Address No.
KV-300 CPU CPU 0, 5
KV-C16X 16-input unit 0
KV-C32X 32-input unit 0. 1
KV-B16R 16-output unit 5
KV-B16S 16-output unit 5
KV-C32T 32-output unit 5, 6
KV-R8X 8-input terminal unit 0 to 4 *
KV-R16X 16-input terminal unit
KV-R8R 8-output terminal unit 5 to 9 *
KV-R16R 16-output terminal unit
KV-R8T 8-output terminal unit
KV-R16T 16-output terminal unit
KVNKA Chap 01P.p65 08.3.11, 11:49 AM 22