KEYENCE Visual KV Series - Manual (Page 9)

(8)
Chapter 2 Editor
Describes the operating procedures in Editor mode.
Chapter 3 Simulator
Describes the operating procedures in Simulator mode.
Chapter 4 Monitor
Describes the operating procedures in Monitor mode.
Appendices
Includes instructions list, devices list, sample program list and quick reference for key
operation and shortcuts.
3 Programming
Chapter 1 Programming
Describes basic knowledge including program creation procedures, device configuration,
relay assignments, special functions to set and confirm Visual KV Series operations, as
well as the extended ladder diagrams. Understand the contents described here com-
pletely at first before creating programs.
Chapter 2 Instructions
Describes the concrete usage of instructions in the KV Series.
Refer to "Chapter 3 Interrupts" on page 3-183 for details of interrupt instructions.
Refer to "Chapter 4 High-speed counters" on page 3-195 for details of the high-speed
counters used in the application instruction.
Chapter 3 Interrupts [Visual KV Series Only]
The interrupt processing function executes an interrupt program when an external input
or request from the high-speed counter comparator (interrupt factor) is encountered
during KV operation.
This chapter describes the types of interrupt factors as well as inputs and outputs
encountered during interrupt processing.
Chapter 4 High-speed Counters [Visual KV Series Only]
Describes high-speed counters and high-speed counter comparators, which allow high-
speed pulse measurement and pulse output, independent of the scan time.
Chapter 5 Positioning Control [Visual KV Series Only]
Describes ramp-up/down control of stepping motors and servo motors.
Chapter 6 Interrupts, High-speed Counters, Positioning Control [KV-300, KV-10/80 Series Only]
Describes ramp-up/down control of stepping motors and servo motors.
Chapter 7 Serial Communication
The KV Series can be connected to an external device with an RS-232C interface to
establish communication.
This chapter describes communications specifications, how to connect the KV Series to
external devices, and how to perform communication.
Chapter 8 Programming Examples
Describes the typical programming examples for KV-10/80 Series. These programs can
be used for Visual KV Series. However, pay attention to the I/O addressing compatibility
before use.
KVNKA Front_Pro.p65 08.3.11, 0:13 PM 9