Demonstrations-modus, Demonstration mode, Demonstrations-mod us – Panasonic NVVX30EG User Manual

Page 150: 0 mix mode (-^ 88) 0, 0 motion-sensor-controlled recording mode, Manuelles auslösen des demonstrations-modus, Ausschalten des demonstrations-modus, Manually activating the demonstration mode, Cancelling the demonstration mode

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

(D

0

m

SNAP

MIX

N

's____ ^____

0

/ s

NEGA

SOLARI

©

----------------

----------------

0

^---------- —-^

WIPE

STROBE

GAIN UP

.

^

J

Panasonic

SEPIA

©

B/W

0

STDBY

MOTION SENSOB

DEUTSCH

ENGLISH

m

Aufnahmemodus Schnappschuß (-» 78)

0 Überblendmodus Mix (*^ 88)

0 Überbiendmodus Wipe

(-*

90)

0 Aufnahmemodus Stroboskop H 92)

0 Aufnahmemodus Aufhellung (•» 94)

0

Aufnahmemodus Negativ

{•*

94)

0 Aufnahmemodus Solarisation (>e 94)

0

Aufnahmemodus Sepia

{•*

94)

0

Aufnahmemodus Schwarzweiß 94)

0 Bewegungssensorgesteuerter Aufnahmemodus

H 9 6 )

0 Demonstrations-Modus

Demonstrations-Modus

Wenn Sie den Netzadapter an den Camerarecorder

anschließen, den Cartierarecorder einschalten, ohne daß

eine Cassette eingesetzt ist, und ihn ohne Auslösen

irgendeiner Funktion ca. 10 Minuten eingeschaltet

lassen, schattet er automatisch auf den

Demonstrations-Modus um. Der Camerarecorder bleibt

so lange in diesem Modus, bis Sie ihn ausschalten und
den Netzadapter von ihm trennen.

■ Manuelles Auslösen des

Demonstrations-Modus

Die Taste [PLAY/DISPLAY SELECT] gedrückt halten
und gleichzeitig den Schalter [POWER] nach außen

drehen. Der Demonstrations-Modus startet 6 Sekunden

später.

■ Ausschalten des

Demonstrations-Modus

Den Schalter [POWER] nach innen drehen, um den

Camerarecorder auszuschalten. Diesen Schalter
anschließend wieder nach außen drehen, während Sie

die Taste [STOP/T.SEL.] gedrückt halten.

0 Snapshot Recording Mode (-►78)

0 Mix Mode (-^ 88)

0

Wipe Mode (-►90)

0 Strobe Mode (-► 92)

0

Gain-up Mode

{-*

94)

0

Negative Mode (-► 94)

0 Solarisation Mode (-► 94)

0

Sepia Mode (-► 94)

0

BiacK-and-White Múde (-► 94)

0 Motion-Sensor-Controlled Recording Mode

(-►96)

0 Demonstration Mode

Demonstration Mode

If you connect the AC Adaptor to the Movie Camera, turn

the Movie Camera on without any cassette inserted, and

leave it on for approximately 10 minutes without

performing any operation, it automaticcilly switches over

to the Demonstration Mode. The Movie Camera remains

in this mode until you turn it off and disconnect the AC
Adaptor.

■ Manually Activating the Demonstration

Mode

While pressing the [PLAY/DISPLAY SELECT] Button,

turn out the [POWER] Switch. The Demonstration Mode
starts after 6 seconds.

■ Cancelling the Demonstration Mode

Turn in the [POWER] Switch to turn the Movie Camera

off. Then turn it out again while pressing the
[STOP/T.SEL] Button.

-

150

-

Advertising