Interlogix XL LCD Keypad Plus Regional Settings Guide User Manual
Page 10
xL Regional Settings Guide
21-3609E rev1.0
6
Entering and Understanding Simplified
Configurations
•
Logon to the system as a service user. Default ID:
“00 or 000”, service user PIN: “2482”.
LCD Screen
Service
Enter PIN: _ _ _ _
•
When the control box
tamper is activated, a
service user has
the authority to access system programming
.
Menu Options
◄ Config ►
↓Ok
•
Using the left and right
arrow screen scrolling
keys on the keypad
scroll the menus until
Config
is displayed. Press
Ok.
•
“Config method” will display. Select “Simplified” and
press Ok. “Configure group?” will display e.g.
“Points”. Press Ok. “Choose Point by” will display
and using the arrow keys, either “Scrolling” the
selection or “Direct Entry” (entering the exact point
number) will display.
•
When the point has been selected and Ok pressed,
the current name for the point number will display.
The option between Editing or Deleting the point
will also display using the arrow keys.
•
If Edit is selected, a cursor will flash under the first
letter of the point’s name. Pressing any
Alpha/Numeric key on the keypad will change the
letter to the characters on that key. Use the left and
right arrow keys to scroll back and forth through the
letters/numbers of the name. To create a blank with
the cursor under the selected character, press the
“0” key until a blank space appears. When ever a
satisfactory setting has been made, always press
the
↓Save button to retain it in memory.
•
When Save is pressed, the next selection for the
Point will be the type it is. Scroll through the
selections to obtain the one required. Press Save.
The next selection will be the Point’s circuit type.
Scroll through the selections to obtain the one
required. Press Save. The next selection will be
what Area the point will be assigned to. Scroll
through the selections to obtain the one required.
Press Save.
•
Points after the defaulted settings will be
“Undefined” and can be selected and edited to be
enabled.
•
These procedures for programming each of the
simplified program sections will be similar.