Interlogix XL LCD Keypad Plus Regional Settings Guide - Manual (Page 44)

xL Regional Settings Guide 21-3609E rev1.0 40
S003 È03 Keypad Selections
ID Number Length 01 – 32 The length of the card ID-number for
primary-format tokens. 20
No. of Bits / Chars 01 – 40 The total number of bits (Wiegand) or
characters (Magstripe) in the card data. 36
Bits per Character 01 – 08 The number of bits used to represent
each character (for magnetic stripe
cards). 8
Card/Token Format 0=none, 1=future
(dallas), 2=Weigand,
3=Magstripe The basic type of card or token
associated with the primary card format
settings. 2
32-Bit / 9-Digit Card IDs: This requires V1.5 door/elevator controller firmware.
S003 È04 Odd Parity Information (Primary)
Keypad Selections (left to right on keypad screen)
Name Selections Description Regional Settings Default
Odd Parity
Position 1 – 40 The position of the odd-parity 'checksum'. 36
Odd Parity Start 1 – 40 This is the position of the first data-bit to be
included for odd-parity checking. 18
Odd Parity Length 0 – 40 If either the odd parity length = 0 or even
parity length = 0, then parity will not be
checked. 18
Odd/Even Parity checking: This feature (which applies only to Wiegand-format cards) helps prevent card misreads.
To disable parity checking: Set the ‘Parity Length’ to 0 (zero).
S003 È05 Primary Card Format—Even-Parity Checking
Keypad Selections (left to right on keypad screen)
Name Selections Description Regional Settings Default
Even Parity
Position 1 – 40 The position of the even-parity 'checksum'. 01
Even Parity Start 1 – 40 This is the position of the first data-bit to be
included for even-parity checking. 02
Even Parity Length 0 – 40 This is the number of bits to be included for
even-parity checking. If either the odd parity
length = 0 or even parity length = 0, then
parity will not be checked. 18
Odd/Even Parity checking: This feature (which applies only to Wiegand-format cards) helps prevent card misreads.
To disable parity checking: Set the 'Parity Length' to 0 (zero).
S004 È00 Secondary Card Format—Site Code Checking
WARNING: S004 È 00 – S004 È 05 Access Control related selections are only available with the addition of
the “Feature Expansion Board”.
Keypad Selections
(left to right on keypad screen) Example:
Name
Selections Description Regional Settings Default
Check for Site Code 9
(yes)
□
(no)
Whether or not secondary-format tokens
must have a specific site code to be granted
entry. † (no)
Site Code Position 1 – 40 The position of the 1st digit for the
site/system code on these access tokens.
Position value changes depending on
site code length.
02
(U.K. ACPO = 03)
Site Code Length 1 – 16 The length of the site code for secondary-
format tokens (number of digits).
Site code
when represented as a digital #. Can not
exceed 4 digits.
08
(U.K. ACPO = 04)
†
· 02·08 ···········
È Save S004 И 00