Interlogix XL LCD Keypad Plus Regional Settings Guide - Manual (Page 64)

xL Regional Settings Guide 21-3609E rev1.0 60
A0xx È08 Keypad Selections (left to right on keypad screen)
NOTE: “xx” represents the area number.
NOTE: Programming selections whose boxes are grey are not available for this version.
Name Selections Description Regional Settings Default
N America 00
European 00
U.K. ACPO 00
Aus/NZ 00
China/H.K. 00
Netherlands 00
Switzerland
00
Activity Timeout Delay Table Time permitted after specific
sensors in an area do not detect
any activity and area is e.g. auto
armed. Delay re-starts if activity
is detected. Sensor Activity
Detection Types: Entry/Exit, FAP
motion sensors, door contacts,
“Activity” Custom Point Types –
see Custom Point programming
section, Command Point – see
Custom Point programming
section.
France 00
N America □ (no)
European □ (no)
U.K. ACPO □ (no)
Aus/NZ □ (no)
China/H.K. □ (no)
Netherlands □ (no)
Switzerland
□ (no)
Include E/E Route
FAP 9
(yes) □ (no)
Whether Entry/Exit Route &
Entry/Exit Route FAP sensors
are used to detect area activity.
FAP – False Alarm Preventer point
type.
France □ (no)
N America □ (no)
European □ (no)
U.K. ACPO □ (no)
Aus/NZ □ (no)
China/H.K. □ (no)
Netherlands □ (no)
Switzerland
□ (no)
Include Doors 9
(yes) □ (no)
Doors are used to detect area
activity.
France □ (no)
N America □ (no)
European □ (no)
U.K. ACPO □ (no)
Aus/NZ □ (no)
China/H.K. □ (no)
Netherlands □ (no)
Switzerland
□ (no)
Alarm On No Activity 9
(yes) □ (no)
France □ (no)
A0xx È09 “Common to Area” Map
Keypad Selections (left to right on keypad screen) NOTE: “xx” represents the area number.
Name Selections Description Regional Settings Default
Area 1 to Area 16 9
(yes)
□
(no)
Auto arm /disarm shared areas.
E.g. Office area and warehouse area with
adjoining lunch room area.
– Lunch room is auto armed when BOTH
office and warehouse are armed.
– Lunch room is auto disarmed when
EITHER office or warehouse is disarmed.
Cannot select current area.
† (no)
All Areas