Interlogix XL LCD Keypad Plus Regional Settings Guide - Manual (Page 49)

21-3609E rev1.0 xL Regional Settings Guide 45
S005 È06 Keypad Selections Telco Modem Init String (left to right on keypad screen)
Name Selections Description Regional Settings Default
Telco Modem Init
String (16 characters) NOTE: Programming selections whose boxes are grey
are not available for this version. Blank
Telco = Telephone Company
S005 È07 Keypad Selections (left to right on keypad screen)
Name Selections Description Regional Settings Default
HSC-IP Account # Enter the 6 digit account # that will
identify this system when it
transmits messages to the HSC-IP
receiver. This account number is also
programmed into the HSC-IP
receiver. 000000
N America 1
European 0
U.K. ACPO
0
Aus/NZ 0
China/H.K. 0
Netherlands 0
Switzerland 0
HSC Mode 0 = Not Used
1 = SIP1 and 2
2 = Not Used
3 = HSC POD (module)
For HSC-IP Enter “1”
SIP = Security IP Receiver
(HSC-IP)
NOTE: SIP1 is not available with
Regional Settings firmware v4.53
and greater. SIP1 is available with
xL firmware v4.48. See SIP1 below.
NOTE:
HSC POD (High Security
Communications) is a proprietary
communications of CSG Security
Inc. and not used in all markets.
France 0
N America 0
European 0
U.K. ACPO
0
Aus/NZ 0
China/H.K. 0
Netherlands 0
Switzerland 0
HSC Timeout 0 = 90sec, 1 = 3min, 2 = 5min,
3 = 10min
For HSC-IP leave defaulted to
“0” Delay before a line failure
occurs.
France 0
N America
0
European 0
U.K. ACPO
0
Aus/NZ 0
China/H.K. 0
Netherlands 0
Switzerland 0
HSC Full Report By
Area 0 = full reporting always, 1 =
use area emergency/full setting
Leave defaulted to “0”
France 0
N America
0
European 0
U.K. ACPO
0
Aus/NZ 0
China/H.K. 0
Netherlands 0
Switzerland 0
HSC-IP Baud Rate 0 = 150, 1 = 600, 2/3 = future
For HSC-IP leave defaulted to
“0”
France 0
N America
0
European 0
U.K. ACPO
0
Aus/NZ 0
China/H.K. 0
Netherlands 0
Switzerland 0
HSC-IP Auto Set 0=manual settings, 1 = SIP
(HSC-IP) receiver sets all
variables
For HSC-IP leave defaulted to
“0”
Future Use
France 0
SIP1
• Security IP version 1 communications will only be available by using version 4.48 xL main control unit firmware.
• SIP version 2 or HSC-IP is available with version 4.53 xL main control unit firmware or greater.
• xL version 4.48 firmware can be obtained on the Director Software CD in “Director Setup\Flash”.
• Once there has been a connection made between a main control unit that does not have version 4.48 firmware and
the Director Software, the Flash Utility available in the Director Software can be used to Flash the main control unit
with the version 4.48 firmware to make it SIP 1 compatible.
• Refer to the Director Software Guide or Director Software Online Help for “Flash Firmware” details.