Interlogix XL LCD Keypad Plus Regional Settings Guide - Manual (Page 100)

96 xL Regional Settings Guide 21-3609E rev1.0
R001 È08 Keypad Selections
N America 10 (1 min)
European 10 (1 min)
U.K. ACPO 10 (1 min)
Aus/NZ 10 (1 min)
China/H.K. 10 (1 min)
Netherlands 10 (1 min)
Switzerland
10 (1 min)
Challenged Door
Held Open Time Delay Table How long the door can be held
open without causing an alarm
after a physically-challenged
user enters. Whether or not the
'Challenged' door held open time
applies is based on the
'Challenged' setting for the user.
For details, refer to U001È02
(“Physically Challenged“
setting).
France 10 (1 min)
N America 14 (5 min)
European 14 (5 min)
U.K. ACPO 14 (5 min)
Aus/NZ 14 (5 min)
China/H.K. 14 (5 min)
Netherlands 14 (5 min)
Switzerland
14 (5 min)
Auxiliary Relay
Output Time Delay Table How long the door can be held
open after access is granted
without causing an alarm.
France 14 (5 min)
N America 0
European 0
U.K. ACPO
0
Aus/NZ 0
China/H.K. 0
Netherlands 0
Switzerland 0
Auxiliary Input Mode 0=None, 1=Mag Lock Bond
Sense, 2=Challenged RTE,
3= (future) Panel Control This specifies how the auxiliary
input on this door-controller
module is to be used.
France 0
N America
0
European 0
U.K. ACPO 0
Aus/NZ 0
China/H.K. 0
Netherlands 0
Switzerland
0
Auxiliary Relay
Output Mode 0=None, 1=Door Held Open /
Door Forced **, 2=Door
Opener *, 3=future Operation of the alarm relay on
the door-controller module
NOTE:
Programming selections
whose boxes are grey are not
available for this version.
France 0
N America □ (no)
European □ (no)
U.K. ACPO □ (no)
Aus/NZ □ (no)
China/H.K. □ (no)
Netherlands □ (no)
Switzerland
□ (no)
Reader Tamper
Required 9
(yes) □ (no)
Whether or not this reader
tamper input is to be monitored.
France □ (no)
N America □ (no)
European □ (no)
U.K. ACPO □ (no)
Aus/NZ □ (no)
China/H.K. □ (no)
Netherlands □ (no)
Switzerland
□ (no)
Reader tamper as
Panel Input 9
(yes) □ (no)
France □ (no)
* Turns on output in this mode when auxiliary input mode is set to challenged RTE and auxiliary input is activated.
** Turns on output in this mode when the condition specified in Door Processing Mode is detected.