Comtech EF Data LPOD-R - Manual (Page 125)

LPOD-R Outdoor Amplifier / Block Up Converter (BUC) MN-LPODR
Optional Serial-based Remote Product Management Revision 1
5–15
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments
for Command
or Response
to Query
Description of Arguments
(Note that all arguments are printable ASCII characters)
Response to
Command
(Target to
Controller)
Query
(Instruction
Code and
Qualifier)
Response to
Query
(Target to
Controller)
IP Address IPA= 18 bytes Command or Query.
Used to set the IP address and network prefix for the 10/100 BaseT Ethernet port, in the form
xxx.xxx.xxx.xxx.yy, where:
xxx.xxx.xxx.xxx = IP address
yy = network prefix (8-30)
Default Value: 192.168.001.004.24
Example: <1/IPG=192.168.001.004.24’cr’
>0001/IPG=’cr’’lf’
Note: Changing the IP address through the Telnet interface requires that you power cycle the unit, and then restart a new
Telnet session with the new IP address (do not include the network prefix, e.g., type in 192.168.1.4 only)
IPA=
IPA?
IPA*
IPA#
IPA? IPA=
xx.xxx.xxx.xxx.y
y (See
description of
arguments)
Gateway
Address
IPG= 15 bytes Command or Query.
Sets or returns the Gateway IP address for the 10/100 Base Tx Ethernet port, in the form xxx.xxx.xxx.xxx.
Default Value: 192.168.001.005
Example: <1/IPG=192.168.001.005’cr’
>0001/IPG=’cr’’lf’
IPG=
IPG?
IPG*
IPG? IPG =
xxx.xxx.xxx.xxx
Initialize
Statistics
Pointer
ISP= None Command only.
Resets the internal pointer to allow RNS? queries to start at the beginning of the stored statistics log.
Example: <1/ISP=’cr’
>0001/ISP=’cr’’lf’
ISP=
ISP?
ISP*
N/A N/A
Retrieve next
5 unread
Stored
Alarms E
N/A 145 bytes Query only.
Returns the five oldest stored events in the alarm log in the form:
YYYYYYYYYY ZZ mmddyy hhmmss’cr’
YYYYYYYYYY ZZ mmddyy hhmmss’cr’
YYYYYYYYYY ZZ mmddyy hhmmss’cr’
YYYYYYYYYY ZZ mmddyy hhmmss’cr’
YYYYYYYYYY ZZ mmddyy hhmmss’cr’’lf’
Where:
YYYYYYYYYY = fault description.
ZZ = one of the following event types:
FT = Fault
OK = Clear
IF = Information
mmddyy hhmmss = date / time stamp.
LNA= LNA? LNA=YY..ss
(See Description
of Arguments for
details)