Comtech EF Data LPOD-R - Manual (Page 68)

LPOD-R Outdoor Amplifier / Block Up Converter MN-LPODR
System Connections, Installation and Startup Revision 1
2–6
2.2.5 Connector J6 | COM1 (Remote Communications and Discrete Control
Port – PS 1, PS 1.5 ONLY)
The J6 | COM 1 discrete control connector is the primary input for controlling and
monitoring the LPOD-R PS1 and 1.5. It is a 19-pin circular connector, type
MS3112E14-19S, used for both standard Ethernet M&C (with use of a 19-pin to RJ-
45 adapter cable) or optional EIA-232/485 Serial M&C. The pinout specification is
contained in Table 2-6
Mating connector: ITT: KPT06J14-19P or MS3116J14-19P
Table 2-6. LPOD-R J6 | COM1 Pin Assignments
Pin Name Description
A RS485_+RX
B RS485_-RX
C RS485_+TX
D RS485_-TX
E RS232_RD Pin 3 of DB9 female connector
F Ethernet TX+ Pin 3 of RJ45 female connector
G RS232_TD Pin 2 of DB9 female connector
H Ethernet TX- Pin 6 of RJ45 female connector
J
TX/RX Switch
Drive 1 Pos
Not for customer use
K Gnd Ground (also Pin 5 of DB-9F connector)
L SUMFLT In Open when faulted, else +5VDC
M SUMFLT Out When faulted, tied to Pin K, else open
N
TX Switch Pos 1
Ind
Online/Offline indication
P
RX Switch Pos 1
Ind
Not for customer use
R +24V Not for customer use
S
System Mute
Control
When AUX=1, unit is muted until this pin is tied to ground (Pin K). When tied to
ground, the unit unmutes. See the AUX remote command in Chapter 5.
OPTIONAL SERIAL-BASED REMOTE PRODUCT MANAGEMENT.
T Switch Common GND reference for Pin N
U Ethernet RX- Pin 2 of RJ45 female connector
V Ethernet RX+ Pin 1 of RJ45 female connector