A.3.1 rf cable (type n) – Comtech EF Data LPOD-R User Manual
Page 140
Advertising
LPOD-R Outdoor Amplifier / Block Up Converter (BUC)
MN-LPODR
Appendix A
Revision 1
A-6
A.3.1 RF Cable (Type N)
Use this Type N cable for the Rx or Tx connections in LPOD-R Standalone or future 1:1 Redundancy applications:
For LPOD-R PS 1 C-Band and X-Band Standalone applications, the cable connects the units J2 | RF OUT port directly to your Rx signal
destination.
For all LPOD-R applications – For Standalone use, the cable connects directly from these LPOD interfaces to your Rx signal destination or
Tx signal source. For future 1:1 Redundancy applications, use the cable to connect the J1 | LBAND IN or J10 | MODEM Rx ports to the
systems respective signal splitters.
Figure A-4. 1/4" Heliax Coaxial Cable (CA/3722-X)
Advertising