Flowserve MX Limitorque - Manual (Page 9)

1
Limitorque MX Maintenance and Spare Parts FCD LMENIM2314-00 – 07/08
flowserve.com
1
Introduction
1.1 Premise
The Flowserve Limitorque MX actuator components are separated into subassembly groupings. This
manual covers the removal and remounting procedures for each subassembly group. Use these instruc-
tions when disassembly is required for service, maintenance, or parts replacement.
1.2 Procedure Emphasis
Please refer to the following methods used to emphasize text throughout this manual. Safety warnings,
cautions, and notes present material that is important to user safety. Be sure to read any safety notices
you see, as they could prevent equipment damage, personal injury, or even death to you or a co-worker.
Safety notices are presented in this manual in three forms:
c WARNING: Refers to personal safety. Alerts the user to potential danger. Failure to follow
warning notices could result in personal injury or death.
a CAUTION: Directs the user’s attention to general precautions that, if not followed, could result in
personal injury and/or equipment damage.
NOTE: Highlights information critical to the user’s understanding of the procedure.
Bold text stresses attention to the details of the procedure.
1.3 Important Notes and Warning Statements
Please read this Maintenance and Spare Parts Manual carefully and completely before attempting to
store or perform maintenance on your MX valve actuator. Further installation, setup, and operation
instructions are available in the Installation and Operation manual (LMENIM2306) located in the actuator
terminal compartment at shipment.