Fluke Biomedical 190M - Manual (Page 47)

Using the Scope and Meter
Making Multimeter Measurements (Model 190M-2)
1
37
The resistor value is displayed in ohms. Observe also that
the bargraph is displayed. (See Figure 15.)
Figure 15. Resistor Value Readings
Making a Current Measurement
You can measure current in both Scope mode and Meter
mode. Scope mode has the advantage of waveforms
being displayed while you perform measurements.Meter
mode has the advantage of high measurement resolution.
The next example explains a typical current measurement
in Meter mode.
XW Warning
Carefully read the instructions about the
current probe you are using.
To set up the test tool, do the following:
1 Connect a current probe (e.g. Fluke 024-74,
optional) from the 4-mm banana jack outputs to
the conductor to be measured.
Ensure that the red and black probe connectors
correspond to the red and black banana jack
inputs. (See Figure 16.)
2
METER
Display the METER key labels.