Fluke Biomedical 190M - Manual (Page 85)

Using Memory and PC
Saving and Recalling
5
75
Notes
The ‘record+setup’ memory locations store more than just
what is visible on the screen. In TrendPlot or Scope
Record mode the full recording is saved. In scope mode
you can save all 100 replay screens in a single
record+setup memory location. The table below shows
what you can store for the various test tool modes.
To save a TrendPlot press STOP first.
Saving Screens in .bmp Format (Print
Screen)
To save a screen in bitmap (.bmp) format, do the
following:
1
SAVE
Display the SAVE key labels.
2
F3
Save the screen to:
− Internal memory (INT) if no
USB device is connected
− a USB device if connected.
The file is saved using a fixed name (IMAGE) and a serial
number, for example IMAGE004.bmp.
If no free memory locations are available a message pops
up that proposes to you to overwrite the oldest data set.
Do one of the following:
If you don’t want to overwrite the oldest data set,
-
press F3 , then delete one or more memory
locations, and save again.
If you want to overwrite the oldest data set,
-
press F4