Gasboy SiteOmat Maintenance Manual - Manual (Page 162)

158
SiteOmat Setup and Maintenance Manual – MDE 4817G
Figure 7-26. Setup Pump Settings Dialog Box
Table 7-4. General Section Parameters
Parameter Description
Pump Number
Identification number of the pump. The logical number defining the pumps.
Pump Head
Address of the pump head, as defined in the dispenser setup, acquired by
technician.
Number of nozzles
Number of nozzles connected to the pump head.
Mode
A pump can operate in two fuelling Modes. In Auto-Authorize mode, the
pump is authorized as soon as the nozzle is lifted. This mode is used when
monitoring of fuelling only is required.
The Authorize mode blocks the pump until an authorization device is used
in any of the available fuelling scenarios.
Pump Server
Select the Pump Server from the drop down list, or click on the ellipsis (…)
button to open the Pump Server dialog box (see paragraph 7-10).