Hypertherm HT200LHF-200 Volt HySpeed - Manual (Page 3)

Changed Page Description IM304 Rev 2 to 3
1/18/99
0.01 Uprevved because of ECNs 10078, 10079, 10070, 9753, 10012, 9864, 10020, 9926
0.06 Changed TOC to reference HT2000LHF Torches
0.08 Changed TOC to reference HT2000LHF Torches
2.01 Added line in spec description to specify recommended production cutting thickness
2.02 Added note to Water Muffler description stating that it cannot be used with the stainless torch
2.03 Added dimension on torch diameter and referenced an additional drawing in Section 6
2.06 Added note to Water Muffler description stating that it cannot be used with the stainless torch
3.07 Added note to Water Muffler description stating that it cannot be used with the stainless torch
3.11 Updated signal labels for I/O cable
3.13 Added note to Water Muffler cable stating that it cannot be used with the stainless torch
4.11 Changed index to cut chart and consumables to include new electrode and swirl ring
4.12-4.29 Updated cut charts with new electrode, swirl ring, and clearer cutting capacities
5.02 Removed old style pump clamp from drawing
6.05 New part number for valve SV7
6.08 Added kits for pump and motor replacement
6.09 New part number for valves SV1-3
6.15 Added new stainless steel torch
6.16 Added new electrode to parts kit
6.17 New part numbers for valves, pump
Begin w/serial # 2LHF-000199
Begin w/serial # 2LHF-000150
Changed Page Description IM304 Rev 1 to 2
8/21/98
0.01 Uprevved because of ECNs 9763, 9758, 9803
0.08 Added figure of coolant flow diagram to TOC
3.08 New graphic of rear panel
5.17 Added figure of coolant flow diagram
6.08 New graphic of rear panel, new p/ns for valve assembly, water pump assembly
7.04 Added coolant flow diagram to wiring diagrams