Hypertherm HT200LHF-200 Volt HySpeed - Manual (Page 50)

INSTALLATION
HySpeed HT2000LHF
Instruction Manual
3-17
6
Valve Cluster and Torch Connections
Routing the Torch Leads
Caution: Before routing the leads, make sure that the torch is removed from the torch leads.
1. If the 12" off-valve hose is connected from the torch to the valve cluster,
disconnect it at the valve cluster. Note that the fitting is left-hand threaded
and turns in a clockwise direction to remove.
2. Slide the torch sleeve over the torch leads and out of the way.
3. Attach the red and green torch leads to the red and green tubes of the torch
main body using a 3/8" wrench to hold the torch fittings, and a 1/2" wrench
to tighten the torch lead fittings.
4. Attach the pilot/shield lead to the shortest tube on the torch main body. Use
a 5/16" wrench to hold the torch body fitting and a 7/16" wrench to tighten
the torch lead fitting.
5. Attach the gray torch lead to the remaining torch fitting. Use a 5/16" wrench
to hold the torch body fitting and a 7/16" wrench to tighten the torch lead
fitting.
Note: If the 12" off-valve hose is not connected to the torch, make the left-
hand threaded connection at this time. Use the same wrenches as in
steps 4 and 5.
6. Slide the torch sleeve over the torch main body and screw together.
Power Supply Side Torch Side
Pilot/Shield Lead
Gray
Red
Green
Figure 3-3 Torch Lead
Connections to Torch
Red and Green Tubes
12" Off-Valve
Hose
Pilot/Shield
Lead
Gray
Route the torch leads from the power supply to the torch through a festoon or a power track.
Connecting the Torch Leads to the Torch
See page 3-8 for torch lead connections to the power supply.
See page 3-7 for torque specifications.
Torch Leads – Power Supply to Torch 22 22 Part No. Length
028657 10 ft (3 m)
028658 15 ft (4.6 m)
028659 20 ft (6.1 m)
028546 25 ft (7.6 m)
028660 30 ft (9.1 m)
028661 35 ft (10.7 m)
028662 40 ft (12.2 m)
028663 45 ft (13.7 m)
028547 50 ft (15 m)