Hypertherm MAX200 Machine Torch Plasma Arc Cutting System User Manual
Page 43
Advertising
MAX200
Instruction Manual
3-15
14
SETUP
Figure 3-6
Plasma Gas and Shield Gas Connections
Plasma Gas
Supply Hose
Shield Gas
Supply Hose
Plasma (Gas) and Shield (Gas) Hoses
When gases other than air are used, connect the liquid or compressed bottled gases to the MAX200 as follows
(see Figure 3-6):
1. Connect the plasma gas supply hose to the PLASMA gas inlet.
2. Connect the shield gas supply hose to the SHIELD gas inlet.
Advertising
This manual is related to the following products: