Format chart – Teac MMR-16 v4.0 User Manual

Page 114

Advertising
background image

TASCAM MMP-16 Owner’s Manual • Chapter 6 • File Format Support

MMP-16

116

Format Chart

The following chart shows the Matrix of formats supported and the various Backup, Export, and
TapeMode Conversion operations available as of Version 4.1 of the MMR-8 and MMP-16 software.

File

Compatibility

Chart

FROM

Wave
Frame

WaveFrame
TapeMode

OMF/SDII

Pro
Tools

ProTools
TapeMode

WaveFrame

Backup

Convert to
TapeMode

Export

Export

Convert to
TapeMode

WaveFrame

TapeMode

Backup

Backup

Export

Export

Convert to
TapeMode

OMF/SDII

Export

Convert to
TapeMode

Backup

Export

Convert to
TapeMode

Pro Tools

See Note

See Note

Export

Backup

Convert to
TapeMode

Pro Tools

TapeMode

See Note

See Note

Export

Backup

Backup *

Akai DD8

Export

Convert to
TapeMode

Export

Export

Convert to
TapeMode

DEVA

(DOS disk)

Export

Convert to
TapeMode

Export

Export

Convert to
TapeMode

Sonic Solutions

(Mac HFS)

Export

Convert to
TapeMode

Export

Export

Convert to
TapeMode

Fairlight MFX 3

Export

Convert to
TapeMode

Export

Export

Convert to
TapeMode

Table of Backup, TapeMode Conversion, and Export Paths

Note: Any file format that can be played on the MMR/MMP can also be written (exported) to any written
format supported by the MMR. Written formats are WaveFrame, Pro Tools, and OMF/SDII. The sole
exception is that Digidesign Pro Tools files may be written as OMF files, but not as WaveFrame files
(shown as Not Permitted in the chart above). To convert Pro Tools to WaveFrame, first export Pro Tools
to OMF on the same disk, then use that OMF file for export to WaveFrame (one extra step).

* This is true only if the Mac HFS disk being copied to is formatted identically (same block size),
otherwise Backup to a Mac volume with a different block size will yield a non-destructive project. In this
case, use Convert to Tape Mode to insure the project remains a TapeMode project after being copied to
the new disk.

Fairlight MFX3 support is provided in MMR Version 4.1 and higher. Support is for files exported in ML
format only, not DL format from the MFX3.

TO

Advertising
This manual is related to the following products: