200 transport – Teac MMR-16 v4.0 User Manual

Page 95

Advertising
background image

MMP-16

TASCAM MMP-16 Owner’s Manual • Chapter 5 • MMP-16 Setup Menus

97

200 Transport

210 Loop Mode

Sets the behavior of the MM series machine when the Loop function is active. The choices for the setting
are:

§ Play Repeatedly

Loops until the transport is stopped (default).

§ Play Once and Cue Plays once from pre-roll before In to post-roll after

Out then cues to pre-roll

before In point and stops.

§ Play Once and Stop Plays once from pre-roll before In to post-roll after

Out then stops at end of post-roll.

211 Loop Record

Sets the behavior of the MM series machine during Loop Record operation. Choices are:

§ Repeat Record

Loop Record until the transport is stopped (default).

§ Record Once Only Records once from In to Out then cues to pre-roll

before In point and stops.

§ Repeat w/Unload Record from In to Out then unloads track and records

new track. Loop record continues, creating a new track
with every loop until stopped.

212 Pre-roll

Sets the amount of time before the In point (called the pre-roll amount) used for loop play and record
functions. The default value is 00:00:05:00.

213 Post-roll

Sets the amount of time after the Out point (called the post-roll amount) used for loop play and record
functions. The default value is 00:00:02:00.

220 Next / Previous Mode

Sets which type of edit is used to determine the location of the next and previous edit points when
working with WaveFrame projects only. These edit points are used in the Go to Next or Go to Previous
edit commands in the transport control section of the ViewNet interface. The default value is Event.

§ Event

Moves the playhead to the next or previous WaveFrame Event.
See the WaveFrame documentation for information on events.

§ Cue

Moves the playhead to the next or previous WaveFrame Cue. See
the WaveFrame documentation for information on cues.

221 Edit Sync Mode

This setting affects where a clip will be pasted during an edit operation.

§ In point Sets the paste to place the beginning of the region stored in the

clipboard at the In point. (default value)

§ Playhead Sets the paste to place the contents of the clipboard to the selected

edit tracks in the same position relative to the Playhead as those
contents occupied when the material was placed on the clipboard.

Advertising
This manual is related to the following products: