Teac MMR-16 v4.0 - Manual (Page 97)

MMP-16 TASCAM MMP-16 Owner’s Manual • Chapter 5 • MMP-16 Setup Menus 99
TASCAM MMR-8
This is the default setting. The TASCAM MMR-8 is the only setting which allows arming of all eight
digital tracks on the MMR. This is the default setting.
Sony PCM-7030
Emulates operation of a two-channel DAT machine. Only tracks one and two can be armed for recording
via the 9-pin port. All tracks can be armed locally or via the TASCAM MM-RC Remote Control Unit.
Sony BVU-950
Emulates operation of this ¾” video deck. Only tracks one and two can be armed for recording via the 9-
pin port. All tracks can be armed locally or via the TASCAM MM-RC Remote Control Unit.
404 Editor Chase
This allows for setting the only P-2 protocol chase source to either Timecode, Biphase, or Disabled. This
governs how the MM series unit responds to Sony 9-pin Chase and Offset commands. The default setting
is disabled.
420 MIDI Device ID
The sets the MM series unit’s MIDI device ID for use with MIDI machine control devices. The
MMR/MMP responds to MIDI Machine Control (MMC) messages received on the unit’s MIDI In port.
To set the MMC address, go to Setup Menu 420, press Trim and set the appropriate MIDI Device ID
number for as required by the device transmitting the MMC messages to which the MMR/MMP will
respond. The range of available MIDI device ID’s is 1 to 127, with the system default being 74.
500 Audio
These settings are used to control the behavior of the system audio functions.
510 Crossfade
This sets the crossfade amount used at punch in/out and edit points. The range is 0 to 100 ms in 1 ms
intervals. The default value is 10 ms.
520 Meter Reference Level
This sets the meter reference level in decibels for the front panel meters of the MM series unit. The
default value is –20dB.
522 Clip LED on Play
This setting determines whether or not the Clip LED on the MM-RC Remote Control Unit will illuminate
when clipping is detected on a playback track. The default value is off.
530 Reference Tone
This activates the internal 1kHz reference tone in the MM series unit. To hear the tone, the unit must be in
play. The default value is off.