Teac MMR-16 v4.0 - Manual (Page 125)

TASCAM MMP-16 Owner’s Manual • Appendix A • Control Panel Summary 127
6 Enter digit, or selects 600 menus (in Setup)
SHIFT+6 Locate to Previous Edit point
STO+6 Stores time code in bottom line of display into Memory register 6.
RCL+6 Recall Previous Edit time into the bottom line of display.
STO Used with the number keys to store the bottom line time code into another
register; loads tracks in Track mode, selects in Setup mode, affirmative response
in other modes
0 Enter digit, or selects 000 menus (in Setup)
SHIFT+0 Lynx sync register
STO+0 Stores time code in bottom line of display into Memory register 0.
RCL+0 Recalls the time code in Memory register 0.
1 Enter digit, or selects 100 menus (in Setup)
SHIFT+1 Offset register (shows machine MMR Bus offset when slave on MMR bus)
STO+1 Stores time code in bottom line of display into Memory register 1.
RCL+1 Recalls the time code in Memory register 1.
2 Enter digit, or selects 200 menus (in Setup)
SHIFT+2 Time Code Reader register
STO+2 Stores time code in bottom line of display into Memory register 2.
RCL+2 Recalls the time code in Memory register 2.
3 Enter digit, or selects 300 menus (in Setup).
SHIFT+3 Free time register
STO+3 Stores time code in bottom line of display into Memory register 3.
RCL+3 Recalls the time code in Memory register 3.
RCL Used to recall a memory register (used with number keys); provide negative
response to query
LOOP When active, loops the transport from the In time to the Out time until Stop is
pressed.
LOC Locates the transport to the time code location in the active register.