Teac HS-2000 - Manual (Page 28)

28
TASCAM HS-2000
3 − Preparations
When the LCD Section is set to LOCK: 0
If the display is touched, the following pop-up •
message appears.
Touch panel display (LCD) locked
If one of the keys around the display is pressed, the •
following pop-up message appears.
Keys around display (LCD) locked
When the Transport section is set to LOCK, if one of the transport 0
keys is pressed, the following pop-up message appears.
Transport section locked
When the REMOTE/KEYBOARD section is set to LOCK, if a remote 0
control or keyboard connected to a remote connector is used, the
following pop-up message appears.
Remote/keyboard control locked
When the EXTERNAL CONTROL section is set to LOCK, if an 0
operation is conducted through the RS-232C, RS-422, PARALLEL or
ETHERNET connections, the following pop-up message appears.
Other external control locked
Recording ties
The table below shows the total amount of recording tie
(in hours and minutes) possible on CF cards of various
capacities for each recording format.
File recording
forat
Card capacity
8 GB
16 GB 32 GB
16-bit/44.1kHz 12:34 25:10 50:21
16-bit/48kHz 11:32 23:07 4616
24-bit/44.1kHz 8:22 16:46 33:34
24-bit/48kHz 7:41 15:24 30:50
24-bit/88.2kHz 4:11 8:23 16:47
24-bit/96kHz 3:50 7:42 15:25
24-bit/176.4kHz 2:05 4:11 8:23
24-bit/192kHz 1:55 3:51 7:42
The recording times shown above are estimates. They •
might differ depending on the CF card in use.
The recording times shown above are not continuous
•
recording times, but rather they are the total possible
recording times for the CF card.