Teac HS-2000 - Manual (Page 48)

48
TASCAM HS-2000
7 – Timeline mode
In this chapter, we explain how to use the unit when its
operation mode is set to TIMELINE MODE. (See “Selecting
the operation mode” on page 47.)
Please refer to “4–Basic operation” when reading this
chapter.
Preparing to record
Basic preparations
Refer to “4–Basic operation” and make the basic
preparations for recording.
Creating a new project
1. Press the PROJECT key on the front panel to open the
PROJECT
screen.
2. Touch the CREATE PROJECT button on the
PROJECT
screen to open the
CREATE PROJECT
screen [1/3].
On this screen, set the project name, the name for the
first session, the sampling frequency and the sampling
frequency written to BWF chunks.
Touch the
NEXT
button to open the next page [2/3].
Set the frame type and bit length.
Touch the
NEXT
button to open the next page [3/3].
Finally, set the timeline mode starting time, and then
set whether other settings should be retained from the
currently open project or whether the factory defaults
should be used instead.
For further details about these settings, see “Creating
new projects” on page 38.
3. After you complete making settings touch the
CREATE PROJECT
button.
NOTE
If a project with the same project name already exists, •
the CREATE PROJECT button appears gray and
you will not be able to create a new project. If this
happens, change the project name.
You can also touch the • CREATE PROJECT button
on
CREATE PROJECT
screens 1/3 and 2/3 to create
a project.
4. Touch the
OK
button when the confirmation pop-up
message appears.
Creating new sessions
Create new sessions as necessary.
1. Press the PROJECT key on the front panel to open the
PROJECT
screen.
2. Touch the w button of the project in which you want
to create a new session to open its session selection
screen.
If the selected project is not the current project, a pop-
up window appears confirming that you want to load
it. Touch the OK button.
3. Touch the
MAKE SESSION
button to open the
MAKE SESSION
screen.