Teac HS-2000 - Manual (Page 98)

98
TASCAM HS-2000
10 – On-air mode
Using the ON AIR button to switch
between rehearsal/confirmation
playback and broadcast playback
modes
You can use the
ON AIR
buttons on the HOME and
ON AIR LIST screens to switch between “rehearsal/
confirmation” and “broadcast” playback modes.
ON AIR • button ON (red): broadcast playback mode
The CREDITS playback button is disabled, and
only the playback area can be played back. (The
CREDITS
playback and
ON AIR LIST
screen
check and file name buttons are also disabled.) When
you switch from OFF to ON, the Home Screen time
counter changes to total time display and playback
pauses at the beginning of the first take.
ON AIR • button OFF: rehearsal/confirmation
playback mode
The
CREDITS
playback button is enabled, and
locating to and playing back any part of a file (take) is
possible.
When you switch from ON to OFF, the Home Screen time
counter is automatically set to elapsed time display.
NOTE
The
ON AIR
button can only be used when the
transport is stopped.
Playback control in on-air mode
Press the PLAY key to start playback.
Press the PAUSE key to pause playback.
Press the PLAY key again to resume playback.
Press the STOP [RETAKE] key to stop playback.
Press the . [MARK .] key or / [MARK /] key
to skip to the next entry.
Press and hold the m [ ] or , [ ] key to
search backward or forward.
Press the . [MARK .] or / [MARK /] key
while pressing and holding the SHIFT key to move
between marks.
Press and hold the m [ ] or , [ ] key while
pressing and holding the SHIFT key to search at high-
speed.
NOTE
On the • PLAY SETUP
screen, you can set whether
only the currently selected take is played or whether
all the takes in the root folder are played. You can also
enable and disable repeat playback. (See “Playback
settings (PLAY SETUP)” on page 102.)
Playback functions can also be performed using •
a remote control connected through the parallel
connector.
Credits playback
This function makes it easy to play just the beginnings of
files.
The term “credits” is commonly used in Japan for the audio
played at the introduction of a program.
1. Turn off the
ON AIR
button on the HOME or
ON
AIR LIST
screen.
2. Set the current file (take) using the
ON AIR LIST
screen file name buttons or the . and / keys.
NOTE
Only playable files can be set as the current take. •
After starting up, changing the Fs or activating on-air •
mode, the first playable file in the list will be selected
as the current take for playback.
3. Touch the CREDITS playback button on the HOME
or
ON AIR LIST
screen to start credits playback
of the current take from its beginning. Playback stops
when the appropriate mark is reached.
When the Follow BWF-J setting is ON, playback •
continues from the beginning of the file to the first
BC$STANDBY mark.
When the Follow BWF-J setting is OFF, playback •
continues from the beginning of the file to the first
mark.
If neither of the above conditions apply, the file plays •
until its end and then playback stops.
During playback, the take name button of the file
being played back appears green on the
ON AIR
LIST
screen.
4. During credit playback, you can press the
CREDITS
playback button to stop playback.
NOTE
The take name and CREDITS playback buttons on the
ON AIR LIST
screen can only be used when the
ON
AIR
button is OFF and playback is stopped or during
credit playback. They cannot be used when the ON AIR
button is ON or during ordinary playback.