Teac HS-2000 - Manual (Page 99)

TASCAM HS-2000
99
10 – On-air mode
Using the call function
Press the CALL [CHASE] key to locate to the point where
playback was last started from playback standby (call
point) and put the unit in playback standby mode.
BWF-J cue point (on-air mode)
When the Follow BWF-J item is set to ON, if a BWF-J
cue point is detected during playback, the following
corresponding operation will occur. In addition, if the
BWF-J Tally Out item is set to ON, in response to each
BWF-J cue point, the cue signal and tally signal will be
output from the parallel remote connector
BC$STANDBY
When the ON AIR button is turned ON, the
transport locates to the first BC$STANDBY point
in the first take as the playback starting point.
During playback, playback pauses when this
type of cue point is detected.* In either case, a
BC$STANDBY tall is output.
*If BC$END Mode is set to Jump to Standby,
playback will pause.
BC$CM
During playback, when this cue point is
detected, a BC$CM CUE signal is output.
BC$END
During playback, when this cue point is
detected, a BC$END CUE signal is output.
"If BC$END Mode is set to Jump to Standby
and the next take has a BC$STANDBY cue point,
playback will continue from that point.
BC$STOP
During playback, when this cue point is
detected, a BC$STOP CUE signal is output, and
playback stops.
BC$FILE
During playback, when this cue point is
detected, a BC$END CUE signal is output. If
there is a BC$STANDBY cue point in the next
entry, playback will move to it and pause at that
point. A BC$STANDBY tally is output.
BC$PAUSE
During playback, when this cue point is
detected, a BC$PAUSE tally is output, and
playback pauses.
Changing the sampling frequency in
on-air mode
You can change the sampling frequency when playback
is stopped in on-air mode using the CLOCK page of the
SYNC T/C
screen.
1. Touch the
SYNC
button on the Home Screen or the
SYNC T/C
button on the
MENU screen to open the
SYNC T/C
screen
CLOCK
page.
2. Touch the
ON AIR Fs
button at the top left of the
screen to open the ON AIR Fs screen.
3. Touch the button for the desired sampling frequency
to open a confirmation message. Touch the
OK
button.
4. When a second confirmation message appears, touch
the
OK
button again.
NOTE
After you change the sampling frequency (Fs), only •
files that match the selected Fs will be shown on the
ON AIR LIST
screen.
Even if the Fs setting matches, files with more than 2 •
channels and other files that cannot be played back by
this unit will not be recognized.
Limitations in on-air mode
Certain settings (repeat mode, auto cue, auto ready, •
incremental play) on the
PLAY SETUP
screen will
be turned OFF when the operation mode is switched
to on-air mode. They can be turned ON, but this
change will not be retained.
In on-air mode, marks cannot be set, edited or
•
cleared. If you press the Mark key, a pop-up appears,
warning “Cannot set Mark point in ON AIR Mode.”
The
• EDIT NAME
,
EDIT TIME
and
DELETE
buttons on the Mark list screen will appear disabled.