Teac HS-2000 - Manual (Page 38)

38
TASCAM HS-2000
5 – Projects
Playlist selection screen
The playlist selection screen is only shown when in playlist
mode.
Session name o
Shows the current session name.
Touch to open the session selection screen.
LOAD o w buttons
Touch a w button to open a pop-up to confirm that
you want to load that playlist.
Playlist name buttons
o
Touch to select a playlist.
The icon
of the currently loaded playlist has the
letter "C" and is yellow.
INFO button o
Touch to open a pop-up window that shows infor-
mation about the selected playlist.
If no playlist is selected, press this button to show
information about the current session.
CREATE PLAYLIST button o
Shows the screen for creating a new playlist.
MENU button o
Touch to open a pull-up menu where you can select
LOAD , EDIT NAME and DELETE .
Scroll buttons o
Use these buttons to scroll to the beginning or end
of the playlist or scroll one page (five lines) forward
or backward. You can also use the DATA dial to scroll
through the playlist one line at a time.
Project operations
Creating new projects
1. Press the PROJECT key on the front panel to open the
PROJECT
screen.
2. Touch the CREATE PROJECT button on the
PROJECT screen to open the CREATE PROJECT
screen.
This screen has three pages.
CREATE PROJECT screen 1
You can make the following settings on this screen.
Project Name 8
Touch the Project Name button to open a screen
where you can edit the project name.
Up to 31 characters can be used for project and
session names. Extra characters are discarded.
Session Name
8
Touch the Session Name button to open
the 1st Session screen where you can change the
name given to the first session created.
On the 1st Session screen, the maximum number
of characters allowed is indicated by a yellow
background.
Fs 8
Set that sampling frequency for the project.
BWF Chunk Fs 8
Set the sampling frequency written to the BWF
chunk of each recorded audio file. To use the
actual sampling frequency of the recordings,
select Actual Rate.
For pull-up/pull-down, select Fake Rate to write
48k instead of 48k ± 0.1%.