Teac HS-2000 - Manual (Page 79)

TASCAM HS-2000
79
8 – Take mode
Combining takes
You can combine two takes into one.
NOTE
You cannot combine takes in the following cases.
The bit lengths, numbers of channels or sampling •
frequencies are different
The file size of the combined takes exceeds the Max •
File Size shown on the
REC SETUP
screen
FILE
FORMAT page
The open space on the media is less than the file size •
of the second of the two takes to be combined
TAKE-1 TAKE-2 TAKE-3 TAKE-4 TAKE-5
TAKE-3 TAKE-4 TAKE-5 TAKE-1
1. Press the HOME key on the front panel to open the
Home Screen.
2. Select a take as the current take. This will be the first
half of the combined take.
3. Touch the
EDIT
button on the Home Screen to open
a pull-up menu.
4. Touch the
Combine
button in the pull-up menu.
5. After the take selection screen opens, touch the w
button of the take to be combined with the current
take as the second half.
(The yellow icon indicates the take that was selected
in step 3 as the first half of the combined take.)
6. A confirmation message appears, and a 4-second
loop of before and after the combination point will be
played.
Touch the OK button or press the ENTER key to
combine the takes.
Touch the
CANCEL
button or press the EXIT/CANCEL
key to stop the loop and reopen the take selection
screen.
7. While the takes are being combined, a progress status
pop-up appears.
When the combination completes, the pop-up window
closes and the Home Screen reopens.
NOTE
The file name of the first take will be used for the •
combined take.
The time code information of the first take will be used •
for the combined take.
If the number of mark points for the combined take •
exceeds 100, all marks after the 100th in order will
be lost. These mark points cannot be recovered with
UNDO
.
CAUTION
You can combine takes that are being used by timeline
and playlist modes.
If you combine such a take, an error pop-up will appear if
you attempt to play the corresponding region or entry.