Verilink 8100A (34-00237) Product Manual User Manual
Page 106
4-32
8 0 0 0 S e r i e s
“Configure PVCs” instead of “Configure DLCIs,” your datalink
protocol is set to ATM instead of Frame Relay.
Figure 4.47
Frame Relay DLCI Configuration Menu
Each option on the menu is described below.
Add New DLCI
To add a new DLCI, follow the steps below.
1
On the Frame Relay DLCI Configuration menu, type “1” to select Add
New DLCI. The IAD prompts you to enter a new DLCI number.
2
Type a DLCI value between 16 and 1023 and press Enter. The IAD displays
the Fame Relay Encapsulation Configuration menu (Figure 4.48).
Figure 4.48
Frame Relay Encapsulation Configuration Menu
3
Type the option corresponding to the encapsulation method you intend to
use. The IAD displays the Frame Relay DLCI Options menu (Figure 4.49).
Figure 4.49
Frame Relay DLCI Options Menu
NOTICE:
To continue without configuring CIR or FRF.12 Fragmentation, press
Escape. CIR is not required for full bandwidth circuits.