Verilink 8100A (34-00237) Product Manual - Manual (Page 34)

1-8 8 0 0 0 S e r i e s
High POTS Port Rear Panel Connectors
The High POTS Port rear panels have the following connectors: 10/100 LAN ,
CONSOLE , T1 (or DSL, depending on model) , DCE V.35/RS-530 (USI) ,
BATTERY BACKUP , Voice Lines , LIFE LINE , On/Off Switch , and AC POWER
INPUT. Each of these is described below. Each unit also has a Ground, a
typical diagram of which is shown in Figure 2.1.
Figure 1.8 T1/E1 High POTS Port Rear Panel Connectors
Figure 1.9 SDSL and SHDSL High POTS Port Rear Panel Connectors
10/100 LAN
(10/100Base-T
Ethernet Port)
Connects the IAD to the local area network using a CAT-5 straight-through
Ethernet cable, or directly to a PC for accessing via Telnet (using a
cross-over, customer-supplied cable). The data interfaces connect through the
IAD supporting IEEE 802.1-compliant bridging and routing. When configured
for routing, supports Routing Information Protocol (RIP) version 1, version 2,
or static IP routing. The IAD complies with RFC-1812 when interfacing with
IPV4 routers. The IAD can terminate the following data interfaces:
• ATM data transport via SHDSL, SDSL, and T1/E1 per RFC 1483 or RFC
2364
•
Frame Relay data transport via SDSL and T1/E1 per RFC 1490
DCE LINK Illuminates when there is a link between the IAD and data
communications equipment (DCE).
DCE ACT Illuminates or blinks when there is activity on the DCE link.
LED Description