Verilink 8100A (34-00237) Product Manual - Manual (Page 94)

4-20 8 0 0 0 S e r i e s
Configure ADSL
Standard
1 Type “1” to select Configure ADSL Standard. The IAD displays the ADSL
Standards menu.
Figure 4.27 ADSL Standards Menu.
2 Type the option corresponding to the ATM Standard. The IAD sets the
standard you select and displays the menu.
Enable/Disable ADSL
Debug Messages
Type “D” to enable or disable ADSL debug messages.
Configure Physical Interface
−
SHDSL
The tasks described in this section all begin on the SHDSL Configuration
menu (Figure 4.28). You should review and update each of these options as
necessary, and always reset the IAD when you finish SHDSL configuration.
To configure the SHDSL interface, Type “2” (Configure Physical Interface)
on the WAN Configuration menu (Figure 4.6) to display the SHDSL
Configuration menu.
Figure 4.28 SHDSL Configuration Menu
Select SHDSL
Interface Type
To select the Interface Type, follow the steps below.
1 Type “1” on the SHDSL Configuration menu (Figure 4.28). The IAD
displays the current SHDSL Interface Type menu. Type the option to select