Configure spanning tree hello time, Configure spanning tree maximum age, Configure spanning tree forward delay – Verilink 8100A (34-00237) Product Manual User Manual
Page 133
C o n f i g u r a t i o n
4-59
1
On the Bridge Configuration menu (Figure 4.69), type “Q” to select
Configure Spanning Tree Port Priority. The IAD displays the interfaces
available on this IAD as shown in Figure 4.60
2
Type the number of the interface for which you want to set the priority. The
IAD displays a port table. If more than one interface is configured on the
selected port, the IAD displays a list of interfaces:
3
Type the number of the port. The IAD prompts you to enter a priority for the
selected Slot and Port.
4
Type the priority value and press Enter. The IAD updates the configuration
and displays the Bridge Configuration menu.
5
Repeat these steps for each port on which you want to set the priority.
6
Continue with other configuration tasks, or press Escape to return to the
Bridge Configuration menu.
Configure Spanning Tree Hello Time
To set the Spanning Tree hello time (a value between 1 and 10 seconds—
default 2), follow the steps below:
1
Type “H” on the Bridge Configuration menu (Figure 4.69) to select
Configure Spanning Tree Hello Time. The IAD prompts you to enter the
Bridge Hello Time.
2
Type the value and press Enter. The IAD updates the configuration.
3
Press any key to return to the Bridge Configuration menu and continue with
other configuration tasks.
Configure Spanning Tree Maximum Age
To set the Spanning Tree maximum age, (a value between 6-40 seconds—
default 20), follow the steps below.
1
Type “S” on the Bridge Configuration menu (Figure 4.69) to select
Configure Spanning Tree Max Age. The IAD prompts you to enter the
Spanning Tree Max Age.
2
Type the maximum age value and press Enter. The IAD updates the
configuration.
3
Press any key to return to the Bridge Configuration menu and continue with
other configuration tasks.
Configure Spanning Tree Forward Delay
To set the Spanning Tree forward delay (a value between 4-30 seconds—
default 15), follow the steps below.
1
Type “F” on the Bridge Configuration menu (Figure 4.69) to select
Configure Spanning Tree Forward Delay. The IAD prompts you to enter the
Spanning Tree Forward Delay.