Logging in via a terminal emulation program, Logging in via a terminal emulation program -4 – Verilink 8100A (34-00237) Product Manual User Manual
Page 40
2-4
8 0 0 0 S e r i e s
Figure 2.1
Typical Grounding Diagram
3
With the console cable connected, plug the AC power adapter into the IAD.
This starts the IAD, and it executes the boot process to begin normal
operation. Verify that the Power indicator on the front panel illuminates.
NOTICE:
For “cold start” access, the IAD default (factory-set) IP address is
192.168.1.254 on the Ethernet side.
NOTICE:
For “Ground Start” applications, all elements in the voice path must be
set to “Ground Start.”
NOTICE:
As the IAD boots, it sends status messages to the console port. If you
are connected, you will see the boot sequence progress.
NOTICE:
This unit should be installed by qualified service personnel only, and
must be connected to a socket outlet with protective earthing
connection.
Logging in via a Terminal Emulation Program
With a serial cable connected, follow the steps below to log in to the IAD:
1
Open a terminal emulation program (Hyperterminal, for example).