Verilink 8100A (34-00237) Product Manual - Manual (Page 85)

C o n f i g u r a t i o n 4-11
The 8000 Series contains a number of predefined configurations for physical
connections and PVCs.
To use one of the predefined configurations, follow the steps below.
1 On the WAN Configuration Menu (Figure 4.4), type “0” to display the
Quick Configuration menu.
Figure 4.13 Quick Configuration Menu
2 Type the option corresponding to the DSLAM to which the IAD is
connected. The IAD automatically resets.
3 To continue configuration, log back onto the IAD.
Configure Physical Interface
−
T1/E1
The tasks described in this section all begin on the T1 or E1 Configuration
menu. The tasks are described in order. Review and update each of the
options as necessary, and reset the IAD when you finish WAN configuration.
Type “2” on the WAN Configuration menu (Figure 4.4) to display the T1
Configuration menu (Figure 4.14).