HEIDENHAIN iTNC 530 (340 49x-05) Pilot - Manual (Page 120)

120
Definin
g
Machining Operations
Additional parameters on the tool detail form:
 DL : Delta length for tool T
 DR : Delta radius for tool T
 DR2 : Delta radius 2 (corner radius) for tool T
 M function: Any miscellaneous function M
 Spindle : Direction of spindle rotation. As a default, smarT.NC sets M3
 Tool preselect : If needed, this is the number of the next tool for faster
tool change (machine-dependent)
Additional parameters on the milling parameters detail form:
 F rate for finishing: Feed rate for the last finishing cut.