HEIDENHAIN iTNC 530 (340 49x-05) Pilot - Manual (Page 94)

94
Definin
g
Machining Operations
Additional parameters on the pocket parameters detail form:
 Allowance for side : Finishing allowance for the side
 Allowance in depth : Finishing allowance for the depth
 Infeed for finishing: Infeed for finishing on the side. If nothing is
entered, finishing is performed in one infeed.
 F rate for finishing: Feed rate for finishing [mm/min], FU [mm/rev]
or FZ [mm/tooth]
 Stepping angle: Angle by which the entire slot is rotated further.
 Number of repetitions: Number of machining operations on a pitch
circle.
 Slot position: Position of the slot referenced to the programmed
position.
Globally effective parameters on the global data detail form:
 Set-up clearance
 2. Set-up clearance
 Feed rate for traversing between machining positions
 Climb milling, or
 Up-cut milling
 Plunge in a helical motion, or
 Plunge in a reciprocating motion, or
 Plunge vertically