HEIDENHAIN iTNC 530 (340 49x-05) Pilot - Manual (Page 197)

197
Processing DXF File
s (Software
Option)
Quick selection of hole positions by entering a diameter
 Select the mode for choosing a machining position. The TNC
hides the layers shown in the left window, and the right
window becomes active for position selection.
 Select the last soft-key row
 Open the dialog for diameter input: enter any diameter in the
pop-up window displayed by the TNC
 Enter the desired diameter and confirm it with the ENT key:
the TNC searches the DXF file for the entered diameter and
then shows a pop-up window with the diameter selected
that is closest to the diameter you entered. Also, you can
retroactively filter the holes according to size
 If required, configure the filter settings (see “Filter settings”
on page 199) and click the Use button to confirm: The TNC
loads the selected positions into the left window (displays a
point symbol)
 If necessary you can also deselect elements that you
already selected, by dragging an area open again, but this
time while pressing the CTRL key