HEIDENHAIN iTNC 530 (340 49x-05) Pilot - Manual (Page 96)

96
Definin
g
Machining Operations
Additional parameters on the stud parameters detail form:
 Allowance for side : Finishing allowance for the side
 Angle of rotation: Angle by which the entire stud is rotated
 Stud position: Position of the stud referenced to the programmed
position.
Globally effective parameters on the global data detail form:
 Set-up clearance
 2. Set-up clearance
 Overlap factor
 Feed rate for traversing between machining positions
 Climb milling, or
 Up-cut milling