HEIDENHAIN iTNC 530 (340 49x-05) Pilot - Manual (Page 179)

179
Processing DXF File
s (Software
Option)
The DXF files to be processed must be stored on the hard
disk of your TNC.
Before loading the file to the TNC, ensure that the name of
the DXF file does not contain any blank spaces or
impermissible special characters.
The DXF file to be opened must contain at least one layer.
The TNC supports the most common DXF-format, R12
(equivalent to AC1009).
The TNC does not support binary DXF format. When
generating the DXF file from a CAD or drawing program,
make sure that you save the file in ASCII format.
The following DXF elements are selectable as contours:
„ LINE (straight line)
„ CIRCLE (complete circle)
„ ARC (circular arc)
„ POLYLINE