HEIDENHAIN iTNC 530 (340 49x-05) Pilot - Manual (Page 15)

15
Quick Guide
 The input field Contour name is active. Create a new contour
program: smarT.NC displays a pop-up window for entering
the contour name. Enter the name of the contour, confirm
with the ENT key. smarT.NC is now in contour programming
mode
 Define the starting point of the contour with X and Y with
the L key: X=10, Y=10, save with the END key
 Approach point 2 with the L key: X=90, save with the END
key
 Define a curvature radius of 8 mm with the RND key, save
with the END key
 Approach point 3 with the L key: Y=80, save with the END
key
 Approach point 4 with the L key: X=90, Y=70, save with the
END key
 Approach point 5 with the L key: Y=10, save with the END
key
 Define a chamfer of 6 mm with the CHF key, save with the
END key
 Approach end point 6 with the L key: X=10, save with the
END key
 Save contour program with the END key: smarT.NC now
displays the form for defining contour machining again
 Save entire contour operations with the END key. Definition
of the contour machining is complete
 Test and run the newly created program as previously
described