HEIDENHAIN iTNC 530 (340 49x-05) Pilot - Manual (Page 43)

43
Fun
damentals
„ CDT tab:
Data for automatic calculation of cutting data
Please also note the detailed description of the tool data in
the Conversational User’s Manual.
The tool type is used by the TNC to determine the symbol
shown in the treeview. Additionally, the TNC also shows the
entered tool name in the treeview.
On the corresponding tabs, smarT.NC does not show tool
data that have been deactivated via machine parameter. In
this case one or more tabs may not be visible.