HEIDENHAIN iTNC 530 (340 49x-05) Pilot - Manual (Page 205)

205
Gra
phica
lly Testing and
Runnin
g a Unit Program
Test Graphics and Execution Graphics
The TNC can graphically display a machining operation in the Execute and
Test submodes of operation. The following functions are available via soft
key:
 Plan view
 Projection in three planes
 3-D view
 Run a program test up to a certain block
 Test the entire program
 Test the program unit-by-unit
 Reset the blank form and test the entire program
 Display / Do not display workpiece blank outline
 Reset workpiece blank
 Display or hide tool
Select the GRAPHICS or PROGRAM+GRAPHICS layout.