HEIDENHAIN iTNC 530 (340 49x-05) Pilot - Manual (Page 140)

140
Definin
g
Machining Operations
Unit 151 Program Call
From smarT.NC you use this unit to call any program of the following file
type:
„ smarT.NC unit program (file type .HU)
„ Conversational dialog program (file type .H)
„ ISO program (file type .I)
Parameters in the overview form:
 Program Name: Enter the path and name of the program to be called.
„ If you want to call the desired program via soft key (pop-up
window, see figure at bottom right), then the program
must be saved in the TNC:\smarTNC directory.
„ If the desired program is not stored in the TNC:\smarTNC
directory, you must enter the complete path.