Precision Digital PD6730X - Manual (Page 48)

PD6730X Vantageview Super Snooper Modbus Scanner Instruction Manual
48
Math Channel Display Setup (MATH)
The Math Channel Display Setup menu is used to configure the display options for each of the four math
channels, CV1 to CV4.
See Math Channel (CV1 to CV4) Programming (MATH) on page 74 for details on programming the math
functions.
Note 1: Menu not applicable to feet and inches display format.
Math Display Format (FORMAT)
The Math Display Format menu is used to configure the display format for each math channel.
Decimal Display Models
The math channel value may appear on the top display (TOPDSP) or bottom display (BOTDSP).
The math channel value may also be turned off (OFF), and will not display; though it may be
used in other math functions.
Feet and Inches Display Models
The math channel may appear on the top feet and inches display with 1/16 of an inch
(FtIn16), 1/8 of an inch (FtIn16), or appear on the 7-digit bottom display (DEC) with no
decimal points. The math channel may also be turned off (OFF), and will not display; though it
may be used in other math functions.
Press Enter to access the Format menu and Up button to scroll through choices. Press Enter to make a
selection and proceed to the next menu.
Press the Menu button to back out of a menu, or hold the Menu button to exit at any time.
Enter Math Channel Tag (TAG)
Each math channel may have a unique programmable tag to identify the math channel while the display
is scanning. To program the tag, select the Tag menu and press Enter.
Program the custom tag as described in Setting Alphanumeric Labels on page 24. When the label has
been programmed, press Enter to confirm the label and leave the Tag parameter.
Press the Menu button to back out of a menu, or hold the Menu button to exit at any time.
Enter Math Channel Units (UNITS)
Each math channel may have a unique engineering unit identifier to display while scanning. To program
the units, select the Units menu and press Enter.
Program the custom unit as described in Setting Alphanumeric Labels on page 24. When the label has
been programmed, press Enter to confirm the label and leave the Units parameter.
Press the Menu button to back out of a menu, or hold the Menu button to exit at any time.
Note 2
Note 1
Ft & In Display
Decimal Display