Precision Digital PD6730X - Manual (Page 90)

PD6730X Vantageview Super Snooper Modbus Scanner Instruction Manual
90
The SafeTouch buttons are designed to constantly recalibrate for ambient conditions. When the
cover position is changed, the cover is removed, or an object is removed that was placed over
the front window, it may take a moment for the SafeTouch buttons to recalibrate to the change in
conditions.
Allow up to 2 minutes for the SafeTouch buttons to recalibrate to new conditions in these cases
where the cover position was changed, or the front window is being unblocked.
IMPORTANT
SafeTouch buttons will not work if two or more buttons are detected as being pressed
simultaneously. As a result, be careful to avoid triggering multiple buttons or reaching
across one button location to press another.
SafeTouch ® Button Tips and Troubleshooting
The SafeTouch Buttons are designed to filter normal levels of ambient interference and to protect against
false triggering, however it is recommended that the SafeTouch
® Buttons be turned off (slide THRU-
GLASS BUTTONS switch to OFF) if there is an infrared interference source in line-of-sight to the display
or if the buttons are not needed.
SafeTouch
® Button Tips:
 To the extent possible, install the display facing away from sunlight, windows, reflective objects
and any sources of infrared interference.
 Keep the polycarbonate window clean.
 Tighten the cover securely.
 Use a password to prevent tampering.
 If the cover has not been installed and secured tightly, it may take a moment for the SafeTouch
buttons to properly self-calibrate when the cover is tightened.
 After all connections have been completed and verified, connect the ribbon cable to the display
module, fasten the display module to the base, install enclosure cover, and then apply power.