Precision Digital PD6730X - Manual (Page 54)

PD6730X Vantageview Super Snooper Modbus Scanner Instruction Manual
54
Set Total Display Decimal Point (TOTAL.DP)
The Total Display Decimal Point menu sets the number of decimal points in the total display. Press Enter
to access the Total Display Decimal Point menu.
Decimal Display Models
Set the display decimal point location for the total display. Pressing the Right arrow moves
the decimal point one place to the right (including no decimal point). Pressing the Up arrow
moves the decimal point one place to the left. Press Enter to confirm the number of decimal
points and continue programming.
Feet and Inches Display Models
Feet and inches display models do not have this menu. On feet and inches display models,
the total appears on the bottom display only, with no decimal locations.
Grand Totalizer Display Setup (GrTOTAL)
The Grand Total Display Setup menu configures the pulse input grand totalizer. For information on setting
up the pulse input, refer to Setting Pulse Input Type (PULSE.IN) on page 58.
This menu is used to configure:
Grand Total Display Format (Top Display, Bottom Display, or Off)
Grand Total Units
Grand Total Display Decimal Point
Note 1: Menu selection is not present in feet and inches display models.
Grand Total Display Format
The grand total display format is selected after pressing Enter at the Grand Total Display Setup menu
(GrTOTAL). If the total is set to off (OFF), then no other total parameters are configured. Otherwise, the
grand total display will be cycled on the display with the Modbus PVs.
On decimal display models, the grand total may appear on the top display (TOPDSP) or bottom display
(BOTDSP).
On feet and inches display models, the grand total may appear only on the bottom display (BOTDSP) with
no decimal points.
Note 1
Note 1