Precision Digital PD6730X - Manual (Page 88)

PD6730X Vantageview Super Snooper Modbus Scanner Instruction Manual
88
Backlight (BAKLITE)
The Backlight menu is used to enable or disable the backlight. After pressing Enter to access the
Backlight
menu, press the Up arrow to Enable (ENABLE) or Disable (DISABLE) for the backlight.
Analog Output Calibration (AO CAL)
This feature is only used at the factory for diagnostic purposes. It is not recommended to access this
menu without instruction from technical support.
Backup & Restore (BACKUP)
The scanner saves all parameter settings and no reprogramming is necessary when power is lost and
restored to the scanner. The total and grand totals are saved during a power loss.
These features are used to save and restore programmed settings. Programming can be restored to a
known saved good configuration, or to factory defaults. This is useful to restore meters whose
programming has been altered in unknown ways, or to quickly restore known good settings if mistakes
are made during reprogramming.
The Save feature (SAVE?) saves all current parameter settings into the memory of the backup restore.
The backup restore feature is loaded with factory default settings until a new configuration is saved.
The Load feature (LOAD?) restores all parameters to the programmed values stored in backup restore
memory. The Load feature will not affect the current password settings, or allow the editing of
permanently locked parameters due to the enabling of the non-resettable grand total feature. See Non-
Resettable Grand Total described on page 81.
CAUTION
Once scanner parameters have been saved to memory by the backup restore feature
there is no recovering the previously saved settings.
Once parameters have been loaded into the scanner from the backup restore feature
there is no recovering the previously programmed settings.
The Default feature (DEFAULT) restores all parameters to the factory default values. Factory default reset
does not change the saved backup restore settings, override passwords, or edit parameters locked by a
permanent non-resettable grand total. See Non-Resettable Grand Total, as described on page 81.
In the Backup menu, use the Up arrow key to select the desired menu. Press Enter to execute the save,
load, or restore defaults command. To restore the scanner to factory defaults, press Enter again to
confirm the request when Defaults? (DEFLTS?) is blinking.
Information (INFO)
The Information menu is part of the System features menu. It shows software identification number,
version number, and extended model number. To view this information:
Go to the Information menu (INFO) and press Enter button.
Continue pressing Enter to scroll through the displays.
Following the information display, the scanner will exit the Advanced Features menu and return to run
mode.