Precision Digital PD6730X - Manual (Page 57)

PD6730X Vantageview Super Snooper Modbus Scanner Instruction Manual
57
Tank Indicator Tank Size (TANKSZ)
The Tank Size menu defines the 100% full level for the 20-segment tank level indicator on feet and
inches display models. This menu is not present in decimal display models. All PV values displayed on
the top line feet and inches display will use this tank level indicator.
To set the maximum height of the tank level indicator, enter the level for thank to display as full. Enter the
full value in feet.
See Setting Numeric Values on page 24 for more information on entering the tank full level in feet.
Press Enter to confirm and save the tank level indicator full value.
Tag Display Time (T-TAG)
If either display is set to toggle a custom tag as part of the Top Display or Bottom Display programming
the scanner will prompt for a toggle time with this menu.
The custom tag for each variable will display before each variable for a number of seconds set by this
parameter. The tag may be programmed to display for 1 to 49 seconds.
Press Enter to access the Tag Display Time menu. Use the Up and Right buttons enter the tag display
time. Press Enter to make a selection and proceed to the next menu. See Setting Numeric Values on
page 24 for more information.
Press the Menu button to exit without saving changes.
Units Display Time (T-UNITS)
If either display is set to toggle units as part of the Top Display or Bottom Display programming the
scanner will prompt for a toggle time with this menu.
The unit for each variable will display before each variable for a number of seconds set by this parameter.
The unit may be programmed to display for 1 to 49 seconds.
Press Enter to access the Units Display Time menu. Use the Up and Right buttons enter the units
display time. Press Enter to make a selection and proceed to the next menu. See Setting Numeric Values
on page 24 for more information.
Press the Menu button to exit without saving changes.
Scan Time (T-SCAN)
The scan time defines how long a variable will be shown on the display while automatically scanning.
After the scan time has elapsed, the next tag, unit, and variable will be displayed.
The scan time may be programmed to cycle the display to the next variable every 2 to 99 seconds.
Press Enter to access the Scan Time menu. Use the Up and Right buttons enter the scan time. Press
Enter
to make a selection and proceed to the next menu. See Setting Numeric Values on page 24 for
more information.
Press the Menu button to exit without saving changes.