Epson LightScene EV-115 2200-Lumen WXGA Laser 3LCD Projector (Black) - Manual (Page 108)

108
Note: You must set the remote control ID to match the projector ID each time you turn on the projector
you have set it to control.
1. Turn on the projector you want the remote control to operate with exclusively.
2. Aim the remote control at that projector and press the ID button on the remote control.
The current projector ID is displayed on the screen for about 3 seconds.
3. Hold down the ID button on the remote control while you press the numeric button that matches the
projector's ID. Then release the buttons.
4. Press the ID button on the remote control to check if the ID-setting process worked.
You see a message displayed by the projector.
• If the remote control is listed as On , the remote control ID is set to operate only the listed projector.
• If the remote control is listed as Off , the remote control ID is not set properly. Repeat the steps
above to set the ID to match the projector you want to control.
Parent topic: Projector Identification System for Multiple Projector Control
Related references
Projector Setup Settings - Extended Menu
Adjusting the Projector's Brightness Level
When projecting with multiple projectors, you must adjust the brightness setting so that all projectors are
equally bright. (Even after adjusting the brightness levels, the brightness of each projector may not
match exactly.)
Note: Make sure the Multi-Projection setting is on ( Menu > Extended > Multi-Projection > On ) before
you adjust the projector's brightness level.
1. Turn on all the projectors and display the same image.