Epson LightScene EV-115 2200-Lumen WXGA Laser 3LCD Projector (Black) - Manual (Page 182)

182
• Make sure the SD card is inserted correctly.
• Make sure the SD card is not write-protected.
• Make sure you use an SDHC card of Class 10 or higher with a maximum capacity of 32GB, or an SD
card formatted in FAT16 or FAT32.
Parent topic: Solving Network Problems
Related tasks
Controlling a Networked Projector Using a Web Browser
Inserting an SD Card
Solutions When Network Alert E-Mails are Not Received
If you do not receive an e-mail alerting you to problems with a projector over the network, try the
following solutions:
• Make sure the projector is turned on and connected to the network correctly. (If an error shut down the
projector, it cannot send an e-mail.)
• Make sure your electrical outlet or power source is functioning properly.
• Make sure you set up the projector e-mail alert settings correctly on the projector's Network
Notifications menu or in the network software.
• Set the Standby Mode setting to Communication On so the network software can monitor the
projector in standby mode. Connect to a wired LAN, or to a wireless LAN with the Connection Mode
setting set to Advanced .Change the Port setting according to your network environment.
Parent topic: Solving Network Problems
Related references
Network Projector E-mail Alert Messages
Related tasks
Setting Up Projector Network E-Mail Alerts
Solutions When the Image Contains Static During Network Projection
If the projected image contains static during network projection, try the following solutions:
• Check for any obstacles between the access point, the computer, the mobile device, and the projector.
If necessary, change their positions to improve communication. Also make sure that they are not too
far apart; move them closer together and try to connect again.